Pioneer SA-9100

Spec

Thanks To Andreas  S. For Nice Pictures And This  is for sale                                   Contact: andreas.salqvist@tele2.se
           Pioneer SA-9100 
Power amplifier
RMS Power Per Channel 60watt/8 ohms, 75watt 4/ohms
Damping Factor @ Load Impedance 70 or above
Total Harmonic Distortion (THD) 0.1% at full power, below .04% at 1 watt
Power Bandwidth 5 Hz to 40 KHz
Frequency Response 7 Hz to 80 KHz, +/- 1 dB
Hum and Noise < .001 Volt (0.13 uW)
Signal to Noise Ratio 90 dB at tuner or aux
Intermodulation Distortion (IM) 0.1% at full power, below .04% at 1 watt
Input Impedance 50 k-Ohm
Input Sensitivity for Full Output 500 mV
Preamplifier
THD 0.03%
Multiple Bass Adjustments 50 Hz, 100 Hz
Multiple Treble Adjustments 10 kHz, 20 kHz
Tone Control Defeat Yes
High Filter 12 KHz or 8 KHz
Low Filter 8 Hz or 30 Hz
Gain Control Yes, with mechanical preset
Loudness Contour Yes
Mono L, R, L+R
Muting -20 dB
Channel Reverse Yes
Balance Yes
Number of Tape Monitors Two
Tape to Tape Dubbing Yes
Auxillary Input Source Yes, independent level control on rear deck
2nd Auxillary Input Source Yes
Phono Input Source Yes
2nd Phono Input Source Yes, independent level control on rear deck
2nd Phono Pickup Impedance Control 100k, 50k, 25k - rear deck access
Tuner Source Input Yes
Source Microphone Input Yes, left
Source Microphone Input 2 Yes, right
Tape Monitor Yes
2nd Tape monitor Yes
DIN Recorder Jack(s) Tape 2 only
Preamp to Amplifier Jumper(s) Yes
Headphone Jack(s) Yes
Speaker Selection Nomenclature A, B, C
Signal to Noise Ratio 90 dB at aux and Tuner
Rated Output Level 2 Volts
Maxiimum Output Level 2 Volts
Output Impedance 8 ohms

 

Physical; Panel Width:16 15/16ths Panel Height: 5 7/16ths Depth: 13 7/16thsWeight: 29 lb, 15 oz

Särskilda egenskaper

 
 

© Loudandproud hifigoteborg